Cirrus Logic CS61880, Руководство пользователя

Страница: 7 / 22

CDB61880
DS450DB1 7
mitters in a high impedance state. Removing the
shorting block, enables the transmitters.
See
Figure 5.
2.6 Clock Edge Selection
In clock/data recovery mode, jumper J93 selects
the edge of RCLK and SCLK on which the
RPOS/RDATA, RNEG, and SDO data signals are
valid. When in data recovery mode, jumper J93 se-
lects the output polarity of RPOS/RNEG. The func-
tion of J93 applies to both the Hardware and Host
mode.
Figure 6 shows the settings for jumper J93
and the effect in both clock/data recovery and data
recovery only mode.
2.7 Jitter Attenuator Selection
In Hardware mode, switch S10 (JASEL) controls
the position of the jitter attenuator for all eight
channels. The corner frequency and FIFO length
can not be changed in Hardware mode. Figure 7
shows the settings for switch S10.
In Host mode, switch S10 has no effect on the
CS61880 device and should be set to the open
(middle) position.
2.8 Loopback Mode Selection
In Hardware mode, the Loopback modes are con-
figured with switches S1 through S8 (0-7).
Figure 8
shows the three different settings for all eight loop
back switches.
In Host mode, switches S1 through S8 must be set
to the NONE (middle) position to allow host inter-
face control.
H I
LO
E n able all eight
transm itters
H i-Z all
eight transm itters
J2
3
TX
O
E
H I
LO
TX
O
E
J2
3
Figure 5. Transmitter Enable Selection
J93
H I
L O
Clock/Data Recovery -
R P O S / R N E G = f a l l i n g
e d g e R C L K S D O =
r i s i n g e d g e S C L K
Clock/Data Recovery -
R P O S / R N E G = r i s i n g
e d g e R C L K S D O =
f a l l i n g e d g e S C L K
Data Recovery -
R P O S / R N E G
polarity active high
Data Recovery -
R P O S / R N E G
polarity active low
CKLE
J93
H I
L O
CKLE
Figure 6. Clock Edge Selection
S 1 0
Hardware Mode
- JA placed in
transmit path
S 1 0
S 1 0
H I G H
O P E N
L O W
H I G H
O P E N
L O W
H I G H
O P E N
L O W
Hardware Mode
- JA Disabled
Hardware Mode
- JA placed in
receive path
J A S E L J A S E L J A S E L
Figure 7. Jitter Attenuator Selection
H a r d w a r e M o d e -
S e l e c t s R e m o t e
L o o p b a c k
H a r d w a r e M o d e -
Selects local
L o o p b a c k
H a r d w a r e M o d e -
Selects no
L o o p b a c k
0 - 7
0 - 7
0 - 7
S1 - S8 S1 - S8 S1 - S8
Lloop
none
Rloop
Lloop
none
Rloop
Lloop
none
Rloop
Figure 8. Loopback Mode Selection