Touch1 LV Checkout Manual - Page 7
Probe Test
The Probe Test tests the ability to correctly identify probed test points. Any one of the
adapters included in the Performance Verification Kit are needed to perform this test.
1. To start the test, press
Next Test: Probe
.
2. A screen will prompt you to install any adapter in the J1 position on the scanner.
Install the adapter in the J1-J2 position as shown and then press
OK
.
3. Touch the tip of the probe to any test point(s) on the adapter. If the probe is
working correctly, a pop-up window will display the correct point(s) touched by
the probe. If no pop-up window is displayed when the test point(s) are probed,
press
No Response.
The test will fail and a Failed Probe Test screen will display.
To display the pop-up
probe window, touch
the probe to any test
point(s) on the
adapter.
4.
Release the probe from the test point(s) and a Passed Probe Test screen
will be displayed. If the screen does not change when the probe is
released from the test point(s), press
No Response.
The test will fail and a
Failed Probe Test screen will be displayed.
