Circutor Wallbox eNext M-C1, Руководство по установке

Страница: 9 / 32

Wallbox eNext
Installation guide 9
Before the
installation
The charge point is designed for installation in indoor and outdoor areas. For each of the
different conditions of installation, the unit must be installed safely and ensure adequate
protection.
• Charge point must not be installed
in areas where there is potential
risk of explosions.
• Do not install the charge point
where falling objects may damage
the equipment.
• The surface where the charge
point is placed must withstand the
mechanical forces.
• This unit is no shall be used for
anything other purpose than
electric vehicle charging modes as
are expected in IEC 61851.
• Do not modify this unit. If
modified,
CIRCUTOR
will reject all
responsibility and the warranty will
be void.
• Comply strictly with electrical
safety regulations according to your
country.
• Do not use any adapter, except those
approved by the EV manufacturer.
• Do not make repairs or
manipulations with the unit
energised.
• Only trained and qualified personnel
should have access to low-voltage
electrical parts inside the unit.
• Check the installation annually by
qualified technician.
• Remove from service any item that
has a fault that could be dangerous
for users (broken plugs, caps that
don’t close...).
• Use only
CIRCUTOR
supplied spare
parts.
• Do not use this product if the
enclosure or the EV connector is
broken, cracked, open, or shows any
other indication of damage.
Refer to TECHNICAL DATA section for more information about environmental
installation conditions.
I M P O R TA N T C H A R G E P O I N T S A F E T Y I N S T RU C T I O N S
Read carefully all the instructions before starting in
order to ensure properly installation of the charge
point.