Circutor VLOG-10, Инструкция по эксплуатации

Страница: 9 / 30

9 Instruction Manual
VLOG-10
3.4.- CONNECTION DIAGRAMS
USB
N
L
POWER SUPPL
Y
POWER
SA
MPLING
EVENT
LOG RESE
T
L
N
CARGA / LOAD
Figure 2:VLOG-10 connection diagram�
3.5.- START-UP
It is necessary to follow these steps before starting the device:
1�- Remove the seal from the internal battery. To do this, pull the seal in the direction of the
arrow, as shown in,
Figure 3
.
USB N
L
POWER SUPPLY
POWER
SAMPLING
EVENT
LOG RESET
Precinto / Seal
Figure 3:Seal from the internal battery�
2�- Configure the device. To do this, connect the device to the USB port of a PC and follow the
instructions described in section “
5.- DISPLAY AND CONFIGURATION.”,
to install the VLOG-10
Software configuration application.