Circutor VLOG-10, Инструкция по эксплуатации

Страница: 16 / 30

16
VLOG-10
Instruction Manual
4.5.- INTERNAL BATTERY
The device comes with an internal battery to protect the data collected during the monitoring of
the mains. This data, and the time, date and the device's configuration, will be kept while the
battery is in an optimal condition (10 years at temperatures of 20ºC -25ºC).
The PC's VLOG-10
Software
application allows the battery voltage to be monitored every time
that the device is connected to the PC.
The battery voltage is shown in the
Factory settings
section of the
VLOG-10 Software
appli-
cation (
“5.2.1.- FACTORY SETTINGS”
)
Table 8: Status of the internal battery�
Voltage Status
3 V Battery fully charged.
< 2�2 V
Low battery level.The battery should be replaced, even if the device is still
working properly.
< 1�7 V
Battery drained, impeding the operation of the device.
The device indicates this status through the alternate flashing of the SAM-
PLING and EVENT LEDs. Connect the device to the
VLOG-10
Software
and check the voltage level of the battery in the Battery voltage param-
eter.
Figure 7:Internal battery voltage�
The device has been designed to autonomously retain data for up to 10 years. However, atmos-
pheric factors such as the storage temperature and humidity may reduce this period.
The internal battery must be replaced by an authorised maintenance service.
The battery must never be replaced with the device connected to the mains
or to the PC via the USB port� There is a risk of electrocution�
Note: When the internal battery is replaced, the device loses all of the settings and the date
and logs stored on it at that time. After replacing the battery, it is necessary to start configuring
the device again using the PC's VLOG-10
Software
application.