Page 22 of 26
When the required value is on the screen, move on to the following digit by
pressing
min
, to allow the remaining values to be changed.
When the last digit has been changed, press
min
to move back to the first digit,
allowing the previously set values to be changed again. In order to enter the
password, press the
key. Once the password has been set, press the
key entering the data and ending the setting.
In the event that the measurement SETUP parameters are to be changed again,
the equipment has to be first unlocked by the same procedure (position “unlo”),
and the appropriate changes are made.
5 APPENDIX – CVM-MINI-ITF-HAR-RS485-C2 SERIES
The
CVM-MINI
Series has an analyzer for the harmonic content up to the 15
th
harmonic in voltage and current, showing the content on the LCD display. Therefore,
the HAR has a high number of display screens, where the value of the current and
voltage fundamental and the content of each harmonic may be seen.
The equipment’s display diagram is obtained by using the following procedure:
Figure 62. Display of Harmonic Content in Voltage and Current
