CircuPool RJ PLUS series, Руководство пользователя

Страница: 27 / 32

25
Lo Salt LED is on / Salinity is out of range Verify salinity (see page 10).
Hi Salt LED is on
Loose cell connection,
Cell is dirty or clogged Ensure correct connection,
clean Cell if necessary.
Incorrect Cell Version set Verify Cell Version in Status Menu.
No Flow LED is on
Incorrect installation Verify correct orientation,
cable is plugged in, 6-12" of
straight pipe before Flow Switch
Insufficient circulation Ensure operation of pump, at
least 25-30 GPM. Check water
level, filter pressure, or for air
or blockages in PVC plumbing.
Water leak O-Ring improperly seated Ensure O-Rings are clean and
in good condition.
Threaded collars are
cross-threaded Inspect threads for damage,
ensure that each screws back
on without resistance.
Real-Time Salinity and
Cell current read zero Zero reading during
normal rest cycle No action is required. Will rise
after rest cycle or raising output
Incorrect voltage Have professional check wiring.
Incorrect Cell Version set Verify Cell Version in Status Menu.
No Flow, Lo Salt, High Salt,
or Check Cell LED on See above.
Cell frequently has
mineral buildup
This is due to imbalanced
water chemistry and a
high Saturation Index Ensure that your Saturation
Index is at or near zero, in
order to avoid damage or
premature cell failure. (p.17)
Cell never or rarely
has mineral buildup Water may be corrosive due
to imbalanced water chem.
and a low Saturation Index
Ensure that your Saturation
Index is at or near zero, in
order to avoid damage or
premature cell failure. (p.17)
HOT or COLD on screen Water temperature is too
hot or cold for operation Check operation of heater, or turn
off until water temp is above 60°.
Cell is dirty or clogged Clean Cell (see p.19).
Damaged Cell or Cell cable Contact manufacturer.
For more information on troubleshooting, visit www.circupool.com/help.