10A
+/-2.0% of reading and +/-2 digits
Resistance:
200-2000-20K-200K-2000K
Ω
+/-1% of reading and +/-2 digits
Input Impedance:
1M
Ω
(DCV/ACV)
Operation Temp.:
0 to 50
o
C
Storage Temp.:
-15 to 50
o
C
Fuse:
GMA 200mA/250V
Power Source:
1 - 9V Battery
Dimensions:
70(W) x 125(H) x 25(D)mm
Weight:
170g (including battery)
MEASUREMENTS
Please take a few minutes to read these instructions prior to use.
1 DC VOLTAGE MEASUREMENT
!
WARNING: Maximum input is 1000V DC.
1-1 Plug the red test lead into the V jack and the black test lead into the COM jack.
1-2 Set the range switch to the desired DCV position. It is best to start with the highest
range if the voltage is not known.
1-3 Attach the test leads to the circuit to be measured. Ensure that the black lead is
connected to the negative side of the circuit and the red lead to the positive.
1-4 Read the displayed voltage.
1-5 If the minus(-) sign appears the voltage is negative at the point being measured.
2 AC VOLTAGE MEASUREMENT
!
WARNING: Maximum input is 750V AC (RMS).
2-1 Plug the red test lead into the V jack and the black test lead into the COM jack.
2-2 Set the range switch to the desired ACV position. It is best to start with the highest
range if the voltage is not known.
2-3 Attach the test leads to the circuit to be measured.
2-4 Read the displayed voltage.
3 RESISTANCE MEASUREMENT
!
WARNING: Remove all power from the circuit being tested when checking
resistance. Discharge any charged capacitors. Never connect the probes to any
voltage while the selector is set to OHM.
3-1 Plug the red test lead into the V jack and the black test lead into the COM jack.
3-2 Set the range switch to the desired
Ω
position. If the resistance is not known, set the
switch to highest range and reduce until a satisfactory reading is obtained.
3-3 Attach the test leads to the circuit.
3-4 Read the displayed resistance.
