A
READ THIS ENTIRE PAGE BEFORE PROCEEDING
FOR THE SAFETY OF PERSONNEL AND TO PREVENT DAMAGE TO THE EQUIPMENT, THE
FOLLOWING NOMENCLATURE HAS BEEN USED IN THIS MANUAL:
DANGER
Failure to observe the precautions noted in this box can result in severe bodily
injury or loss of life.
WARNING
Failure to observe the precautions noted in this box can cause injury to per-
sonnel by accidental contact with the equipment or liquids. Protection should
be provided by the user to prevent accidental contact.
CAUTION
ATTENTION
Failure to observe the precautions noted in this box can cause damage or
failure of the equipment.
Non-compliance of safety
instructions identified by the
following symbol could
affect safety for persons:
Safety instructions
where electrical
safety is involved
are identified by:
Safety instructions which shall
be considered for reasons of
safe operation of the pump
and/or protection of the pump
itself are marked by the sign:
ATTENTION
ATTENTION
If operation of this pump is critical to your business, we strongly recommend
you keep a spare pump or major repair kit in stock at all times. As a minimum,
a minor repair kit (o-rings, gaskets, shaft seal and bearings) should be kept in
stock so pump refurbishment after internal inspection can be accomplished.
CONTENTS
Safety and Table of Contents ....................................................................................................... A
General Instructions ..................................................................................................................... 1
Ordering Instructions ..................................................................................................................... 1
Introduction ................................................................................................................................... 1
Maintenance .................................................................................................................................. 3
Bearing and Mechanical Shaft Seal Disassembly ........................................................................ 4
Bearing and Mechanical Shaft Seal Resassembly ....................................................................... 5
