6
!
Keep records of scheduled programs for maximally 15 days after power off.
7
!
Run 5 minutes high speed when first start the pump
8
!
Step-by-step acceleration and deceleration of the speed to extend the use life of the
motor and control panel
2. Introduction of LED Control Board
!
ECO: Press to select and run on default speed 1500 PRM, can adjust from 1000 to 2400
RPM
"
CLEAN: Press to select and run on default speed 2400 PRM, can adjust from 2400 to 2850
RPM
#
BOOST: Press to select and run on default speed 3250 PRM, can adjust from 2850 to 3450
RPM
$
STOP: Press to stop the pump. The screen displays the present time
%
MENU: Accesses the pump menu if the pump is stopped
&
MODE 1 : To run the programmed 16 hours clean cycle.
'
MODE 2 : To run the programmed 24 hours clean cycle.
(
Enter: Save and exit the menu.
)
ARROW BUTTONS:
•
UP ARROW
–
Move up on e level in the menu or to increase a digit when changing a
setting
•
DOWN ARROW
–
Move one level down in the menu or to decrease a digit when
changing a setting.
•
LEFT ARROW
–
Moves the cursor left one digit when changing a setting
•
RIGHT ARROW
–
Moves the cursor right one digit when changing a setting
*
LED Screen: Composed of four digital tubes. Display current time when in standby. And
display the current and running speed back and forth in operation.
+
AM/PM: Designed for 12-hours system. If pump run on 0:0 0 -11:59, AM light on ;
run on 12 :00 - 23:59, PM light on.
,
MODE1 and MODE 2 have 4 stages,
S1/S2/S3/S4 is the speed for each stage. If the S1
light is on, the pump is run on first stage, if the light twinkles, the time for the stage is not
arriving yet or the pump is no t running. If SPEED light is on, the screen will display the current
RPM. If HOUR light twinkles; you are ready to set the running time for each stage. If ALARM
light is on, an alarm condition exists.
-
Press MODE 1,the light will be lit and one light of S1/S2/S3/S4 will be on or twinkle.
(Light twinkle means the current time is no t du ring the set running period), and on e of AM or
PM light will be on.
.
Press MODE2, the light will be lit and the one light of S1/S2/S3/S4 will be on o r
twinkle.(Light twinkle means the current time is not during the set running period), and one of
AM or PM light will on.
/
When the pump is in standby switch MODE 1 and MODE2, the corresponding light will be
lit, and the pump run accordingly.
7
