FuzzySca
n
Pr
o
g
ram
mi
ng Ma
n
ua
l
Configuring Your Scanner
59
PROGRAM
Operation Control
Operation Mode, Illumination Control
F_DEFAULT
Family Code Selection
P.C
Parameter Selection
Option Code
Operation Mode
SS
SS
SS
SS
Trigger mode
Presentation mode◄
Force mode
Multiple Read Mode
1
2
9
C
Illumination Control
SS
SS
Disable
Enable◄
0
1
Trigger Mode (External Triggering):
The scanner begins its scan session upon a pressed trigger button or receiving a Trigger On serial command. The light source of the
scanner keeps on before scanning the barcode. The scan session ends if the scanner successfully decodes a barcode (Good Read), when its trigger button is released, or
when a preset
Hand-held Scan Time-out
duration is up. After the scan session ends, the scanner goes into standby state waiting for next scan session.
Presentation Mode (Auto Detection):
Under this mode, the scanner keeps its background lighting on and continuously looks for any object approaching in (motion detect
state). Once it detects a approaching object, the scanner begins its scan session with its light source fully on. The scan session continues until the scanner successfully
decodes a barcode (Good Read) or a preset
Presentation Scan Time-out
is up. If the session is over because of a successful scan, it re-starts next scan session
immediately. If the session is over because time-out duration is up, it changes back to motion detect state and looks for next object approaching in. You can disable
Image
Sensing Background Lighting
if necessary. However, if the ambient light condition in the room is not good enough, the Presentation Mode may not work properly. You
can also choose different level of sensibility to meet your application (Please refer to the setting of “
Image Sensing Sensitivity
”).
Force Mode (Continued Power On):
The scanner always turns on its light source for continuous operation without triggering. This mode is convenient for high speed
barcode reading.
Multiple Read Mode:
The scanner begins its scan session upon a pressed trigger button or receiving a Trigger On serial command. The light source of the scanner keeps
on before scanning the barcode. The scan session ends if the scanner successfully decodes a barcode (Good Read), when its trigger button is released, or when a preset
Hand-held Scan Time-out
duration is up. Once it has a good read, the scanner will emit a beep sound, start a new scan session, and reset the time-out immediately. If the
scan session ends because the time-out duration is up or the trigger is released, the scanner will goes into standby state waiting for next scan session. Multiple read mode
allows the scanner to decode multiple barcodes with a single press of the trigger. When you press and hold the trigger to aim at a series of barcodes, the scanner decodes
each barcode and beep for each good read. For more precise barcode decoding, you are recommended to enable
Center Alignment
function while multiple read mode is
selected. You can also enable
Unique Barcode Reporting
function to avoid reading the same code multiple times in a same scanning session
.
Operation modes categorized as “Hand-Held Mode”: Trigger mode and Multiple read mode
Operation modes categorized as “Hand-Free Mode”: Presentation mode and Force mode.
The
Illumination Control
is only available for Trigger mode and Multiple read mode. With it enabled, the illumination LED light up when user presses the trigger, and vice
versa.
Содержание Fuzzyscan
