Cinegears MULTI AXIS FOLLOW FOCUS, Руководство пользователя

Страница: 13 / 26

Instruction
© 2014 CINEGEARS All Rights Reserved
Manual Calibration
Specifically used with infinity lenses that have no start or end point. Press the SET and REC button on
the wireless controller together for 3 seconds, and you will see the A, B, C, D lights are turn on. Then
use the (C) button or (D) button to control the motor. (Hold down the C or D key for more than 3 seconds
it will automatically rotate clockwise or counter clockwise.) Once it rotates to the proper position, click the
(A) button as a starting point, the gear will spin the opposite direction. Then when you find the desired end
point press the (B) button. Finally the (A, B, C, D) four buttons lights turn off to indicate the calibration has
been completed.
After the lens calibration, the swivel will automatically shorten the distance for a slight amount to avoid the
noise of the motor stopping.
Blackout
The controller and motor are able to store data in case of a sudden power loss or battery replacement.
The data from your shoot/lens calibration is saved and the operation can continue once the power is
turned back on. If the drive or Lens has been dismantled or replaced, or the corresponding position of
gears has been changed you will need to repeat the calibration.
Buttons and Lights
※ When blue (SET) and (COM) lights flash regularly at 3 times / sec, indicates that it is communicating
properly.
※ The (SET) light stays in dark when connection failed due to long distance, signal break or initialization
failure.
※ SET ＋ A (click for 3 sec) automatic calibration
※ SET+ O (click for 3 sec) push to synch controller to motor
※ REC (single click) record ／ pause
※ SET ＋ REC (click for 3 sec) manual calibration
※ A,B,C,D (single click) move to the pre set focus point
※ A, B, C, D, click for 3 sec, press and hold any one of them to set your focus point. The lights on all four
buttons will flash to indicate the preset has been saved.
※ Once the preset has been set, push any of the lettered buttons. The indicator lights for A, B, C, or D will
turn on, it means their positions are being used, push another lettered button to move to that point or
push the one that is already lit up to return to manual mode.
※ If the (COM) light on the motor is not on, it indicates that the controller is out of the range or there is no
power.
※ The (COM) button on the motor is also used as an indicator. Pushing the button for 3 sec will turn the
blue light to green to signal you to connect to the controller. During normal operation, a single push of
the C-­Code button can change the direction of the gear. The color of the light will change with the
direction of the gear.