CIMLINE M Series, Руководство владельца и оператора

Страница: 34 / 76

34
M-Series Maintenance - Tank Burner
Bleeding The Fuel Supply Line (Older Melter Units):
More recent CIMLINE Melters us a Clean-Cut Fuel Pump on the Beckett Burner units. These more
modern fuel pumps are self priming and this process should not be needed.
In the case of older Beckett Burner units there may be a need to bleed air from the fuel line if the
burner has run completely out of fuel. To bleed the pump, attach a clear plastic hose over the vent
fitting (C). Loosen the fitting and catch the fuel in an empty container. Tighten the fitting when all air
has been purged from the supply system. Note: If the burner stops after a flame is established, the
unit probably requires additional bleeding. Continue to bleed the system until the pump is primed and
a flame is established when the bleed valve is closed.
Tank Burner Chamber Lining:
After initial 200 hours of operation, the chamber lining must be inspected. Cracks in lining may occur
and should be regularly inspected and monitored. If cracks expand excessively a new lining kit should
be ordered to replace worn lining.
Remove tank burner mount bolts (A) and pull out burner and mount. Inspect lining (B) for excessive
cracking. If cracks exceed guidelines, contact your CIMLINE dealer to purchase a replacement PN#
403400 Burner Chamber Lining Kit.
(A)
1
2
3
4
5
6
7
8
(B)
(C)
Assemble chamber insulation
in the order shown 1-8.
Do not run machine if cracks are wide enough to allow flame to
contact the metal combustion chamber walls or if any piece has
broken loose. Do not attempt to repair cracks.
NOTICE
Contact with lining may cause skin or eye irritation, wear long
sleeve shirt, gloves, and goggles when inspecting lining.
CAUTION