15
SHUTTNG DOWN LP BURNER
To shut down for an extended period, close the Main Valve on LP tank. This will allow the gas
in the line to bleed out. The burners may run for a minute until the gas is purged.
Close the Ball Valve attached to regulator.
When shutting down for the day, put LP Tank in a safe place. Do not leave installed on kettle.
WARNING! SHUT OFF BURNERS BY CLOSING MAIN LP TANK VALVE. DO NOT SHUT
OFF BURNER BY CLOSING THE BALL VALVE ON REGULATOR. HOSES AND CON-
NECTIONS CAN HAVE SMALL LEAKS THAT WILL DRAIN YOUR LP TANK.
THE LP BOTTLE SHOULD BE SECURE, UPRIGHT AND AWAY FROM HEAT.
WARNING! NEVER LEAVE THE KETTLE UNATTENDED WHILE RUNNING. IT IS VERY
IMPORTANT THAT THE OPERATOR READS AND UNDERSTANDS THESE
INSTRUCTIONS.
__________________________________________________________________________
FLUSHING PUMP/HOSE/WAND
Shut Spray Wand valve.
Make Sure Bypass Valve is closed completely.
Turn Main Tank Valve from “PUMP MATERIAL” to “PUMP SOLVENT”.
Open Solvent Tank Valve located at front of solvent tank.
Solvent will now pump through Hose and Wand.
Hold tip of Spray Wand over a container and SLOWLY open Ball Valve on Wand to flush solvent
from Hose and Wand.
Spray until an uninterrupted flow of solvent comes out of Wand.
Close Spray Wand valve.
Close Solvent Tank Valve
Shut off Engine.
SOLVENT TANK VALVE
