15
Installing the X2 Continued
Securing the X2
1) Using four (4) ratchet straps rated for a minimum of 500 pounds each, attach one
end of each strap to the load hooks typically found in each corner of the bed.
CAUTION!
The X2 will tip forward or on its side if not properly secured, leading
to possible injury or equipment damage. Four (4) separate straps are
REQUIRED
to prevent tipping. Passing a single strap through both loops
to lash to the opposite corner
DOES NOT
properly restrain the unit and allows it
to slide on the straps and tip.
2) The straps at the cab end of the bed are to be strung to the tie down loops at the
top of the column.
4) After all straps are strung, begin tightening starting with the rear passenger corner.
Followed by the rear drivers, front passengers, and the front drivers. Lastly go back
through and confirm all are tight.
Permanent Mounting Options
The X2 is supplied with foot pads that allow for either bolting or welding the unit to the
truck bed. For installation using either of these methods consult your vehicles owners
manual or contact a professional aftermarket installer of hitches or truck bodies.
3) The straps at the rear corners of the bed are to go to the square tubes at the top of
the compressor.
Содержание 301-000-000
Страница 34: ...34 Notes ...
Страница 35: ...35 ...
Страница 36: ...2601 Niagara Lane Plymouth MN 55447 763 557 1982 800 328 3874 Fax 763 557 1971 ...