TRANSTIG 200 Pi
SERVICE MANUAL
4-8
March 31, 2008
4.07 Sequence of Operation
NOTE
Scroll Buttons are used to select the parameters to be set. The LED’s show which function is being
adjusted on the weld sequence graph. Refer to Symbols Table located in the front of the manual for
Symbol descriptions.
Figure 4-5: Transtig 200 Pi Front Panel
A
r
t # A-06034_AB
1
2
3
8
4
5
6
7
1. Pulse Function:
Pressing this button enables the
TIG current pulse functions.
2. Scroll Buttons:
used to select the parameter to
be set. The LED’s show which function is being
adjusted on the weld sequence graph.
3. Digital LED Display:
Welding amperage and
parameter values are displayed in this window.
Internal warnings such as over temperature, low
or high input voltage applied are signaled to the
operator by a warning sound and error message
on the screen.
4. Control Knob:
allows the operator to adjust the
output amperage within the entire range of the
power source, also used to set each parameter
value. Pushing the knob inward displays the actual
welding voltage.
5. Process Button:
This button selects between
STICK, Lift or HF TIG mode.
6. 8 Pin Remote Control Receptacle:
for connecting
remote device.
7. TIG Mode Functions:
Pressing this button scrolls
through the output TIG function modes (Standard,
Slope, Slope w/repeat, Spot).
8. Save/Load Button:
by using the Save & Load
buttons the operator can easily save up to 5
welding parameter program. NOTE: SAVE/LOAD
button must remain depressed for 3 seconds in
order to save or load the settings.