CID Severe Duty 20-30 GPM Series, Руководство пользователя

Страница: 20 / 52

Severe Duty Bent Axis Piston Brush Cutter
March 2021
19
3.4 First Time Use Procedure
3.3 How To Start and Stop The Brush Cutter Cont.
If the brush cutter begins to vibrate while increasing the RPM’s, flip the
auxiliary hydraulic switch to the OFF position and investigate the cause.
Refer to the Troubleshooting Chart on page 35 of this manual.
Stopping the Cutter
1. Raise the cutter slightly and set skid steer’s engine to idle.
2. Allow the cutter to slow down.
3.
Shut off hydraulic flow to the brush cutter.
ALWAYS release the hydraulic system pressure from the auxilary
hydraulic circuit prior to removing the attachment or performing any
hydraulic service work.
Before operating the brush cutter, check the skid steers hydraulic oil level
and add oil if necessary.
Make sure the case drain hose is properly attached to the prime mover’s
case drain connection. DO NOT operate this attachment WITHOUT the case
drain hose attached. Excessive hydraulic pressure will blow out the seals.
Verify that hydraulic hoses are securely locked to the skid steer hydraulic
couplers before starting the brush cutter.