CI-340 Operation Manual
CID Bio-Science
1554 NE 3
rd
Ave
Camas, WA 98607, USA
Phone: +1 (360) 833-8835
Fax: +1 (360) 833-1914
[email protected]
www.cid-inc.com
42
4.
Connect the DC coupler to the charger/adapter’s DC terminal.
TO DISCONNECT THE CHARGER/ADAPTER
1.
Turn the CI-340 off and detach the DC coupler.
2.
Disconnect the DC coupler from the charger/adapter.
3.
Unplug the charger/adapter and disconnect the power cable from the charger/adapter.
TO CHARGE THE Li-ion BATTERY
Figure 10-2. Attach the Li-ion Battery to the charger/adapter.
Note: Make sure that the DC coupler is not connected to the charger/adapter. The Li-ion Battery will
not charge if the DC coupler is connected to the charger/adapter.
1.
Connect the power cable to the charger/adapter. (See Figure 10-2.)
2.
Plug the power cable into a lab power socket.
3.
Attach the Li-ion Battery to the charger/adapter.
•
Align the front end of the Li-ion Battery with the guides on the charger/adapter, then press and
slide the Li-ion Battery into the charger/adapter to set it in place.
•
The red charge indicator will flash while the Li-ion Battery is charging. Single flashes indicate
that the Li-ion Battery is charged less that 50%. Double flashes indicate that it is 50-75% charged.
Triple flashes indicate that it is more than 75% charged. The indicator shines steady when the
Li-ion Battery is fully charged.
4.
Remove the Li-ion Battery.
5.
Unplug the charger/adapter and disconnect the power cable from the charger/adapter.
NOTES
•
If the charger/adapter does not seem to be working, this may be because its safety circuit has been
activated. Unplug the charger/adapter, wait a few minutes, and plug it in again.
•
The charge indicator does not light up when the DC coupler is connected.
Содержание CI-340
Страница 3: ......
