05
Installing, starting up, and servicing air-conditioning equipment can be hazardous due to system ressures,
electrical components, and equipment location (roofs, elevated structures, etc.).
Only trained, qualified installers and service mechanics should install, start-up, and serve this equipment.
When working on the equipment, observe precautions in the literature and on tags, stickers, and labels attached
to the equipment.
Follow all safety codes. Wear safety glasses and work gloves. Keep quenching cloth and fire extinguisher
nearby when brazing. Use care in handing, rigging, and setting bulky equipment.
Read these instructions thoroughly and follow all warnings or cautions included in literature and attached to the
unit. Consult local building codes and National Electrical Code for special requirement.
1.2 ACCESSORIES
The following accessories are supplied with the unit. The type and quantity may differ
depending on the specifications.
1.3 INSTALLATION SITE CHOOSING
3
1
Name of Accessories
Manual
Q‘ty(pc)
Shape
1
1
Drain outlet
Gasket
Installation plate
Name of Accessories
Q‘ty(pc)
Shape
Anchor
5
Screw A
5
1
2
1
2
Screw B
Remote controller
Remote controller holder
Battery
Indoor Unit
- A location which can bear the weight of indoor unit.
- Do not install indoor units near a direct source of heat such as direct sunlight or
a heating appliance.
- A location which provides appropriate clearances as below figure.
- Moving parts of appliance must be installed/located at the level not less than 2.3m from
the floor.
Outdoor Unit
- A location which is convenient to installation and not exposed to strong wind. If unit is
exposed to strong winds it is recommended that a wind baffle be used.
- A location which can bear the weight of outdoor unit and where the outdoor unit can be
mounted in a level position.
- A location which provides appropriate clearances as below figure.
Do not install the indoor or outdoor units in a location with special environmental
conditions.
Confirm that there is enough room for installation and maintenance.
Note: Ensure the spaces indicated by arrows from the wall, ceiling, fence or other obstacles.
15cm or more
2.3m or more
60cm or more
30cm or more
12cm or more
12cm or more
30cm or more
Piping is possible in the rear, left, left rear and right direction.
200cm or more
60cm or more
Plug the unused
drain hole with the
rubber plug
provided.
Cut the knock-out
panel according to
the piping size.
knock-out panel
1. PREPARING FOR INSTALLATION
1
Small Filter
1. PREPARING FOR INSTALLATION
06
Magnetic ring
(Some units)
N*
* means that according to the actual quantity.
Mode
T
imer
T
u
rb
o
ION
LE
D
ON/OFF
Fan
F
ollow m
e
S
el
f
clea
n
GB
