20
19
Usage
The keypad can be used as a remote control. User code or
admin code should be input before the operation of Arm,
Disarm, Stay Mode, and Mute Mode.
Arm
When the alarm panel receives the signal, the siren will beep
once and the Arm indicator will light on. The alarm system
enters armed state.
If there is an intrusion, the alarm system will be triggered, the
siren will hoot and the control panel will send SMS and auto
dial to pre-stored phone numbers to notify users. (SMS
notification is applicable only for GSM alarm systems.)
Disarm
Users can disarm alarm system by using keypad or by using
RFID tags.
Using Keypad to Disarm
Input user code or admin code, and press
key, the
LED indicator flashes once and the keypad beeps once and
sends Disarm command to the control panel.
[Disarm]
When the alarm panel receives the signal, the siren will beep
twice and the Disarm indicator will light on, the alarm system
enters disarmed state. In this state, the sensors being
triggered will not cause an alarm.
Using RFID Tag to Disarm
In power saving mode, user needs to press
to wake up the
keypad and then put RFID tag close to the reader to disarm or
unlock the door.
In non power saving mode,
user can put RFID tag close
to the reader to disarm or
unlock the door directly.
[*]
Input user code or admin code, and press
key, the
LED indicator flashes once and the keypad beeps once and
sends Arm command to the control panel.
[Arm]
