Chrysler Sebring Convertible, Руководство пользователя

Страница: 157 / 454

It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLink
t
for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
when programming.
1. Turn the ignition switch to the ON/RUN position.
2. Hold the battery side of the hand-held transmitter
away from the HomeLink
t
button you wish to program.
Place the hand-held transmitter 1–3 inches (3–8 cm) away
from the HomeLink
t
button you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both the chosen
HomeLink
t
button and the hand-held transmitter button
until the HomeLink
t
indicator changes from a slow to a
rapidly blinking light, then release both the HomeLink
t
and hand-held transmitter buttons.
Watch for the HomeLink
t
indicator to change flash rates.
When it changes, it is programmed. It may take up to 30
seconds, or longer in rare cases. The garage door may
open & close while you train.
NOTE:
•
Some gate operators and garage door openers may
require you to replace Step #3 with procedures noted
in the “Gate Operator/Canadian Programming” sec-
tion.
•
After training a HomeLink
t
channel, if the garage
door does not operate with HomeLink
t
and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so,
proceed to the heading “Programming A Rolling Code
System.”
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 157
3