![Chrysler 300 SRT 2019 Скачать руководство пользователя страница 21](http://html1.mh-extra.com/html/chrysler/300-srt-2019/300-srt-2019_owners-manual_2606124021.webp)
3. Remove the battery by turning the back
cover over (battery facing downward) and
tapping it lightly on a solid surface such as a
table or similar surface, and then replace the
battery. When replacing the battery, match
the + sign on the battery to the + sign on the
inside of the battery clip, located on the back
cover. Avoid touching the new battery with
your fingers because skin oils may cause
battery deterioration. If you touch a battery,
clean it with rubbing alcohol.
4. To assemble the key fob case, snap the two
halves together.
Programming Additional Key Fobs
Programming the key fob may be performed by
an authorized dealer.
NOTE:
Once a key fob is programmed to a vehicle, it
cannot be repurposed and reprogrammed to
another vehicle.
Request For Additional Remote Controls
NOTE:
Only key fobs that are programmed to the
vehicle electronics can be used to start and
operate the vehicle. Once a key fob is pro-
grammed to a vehicle, it cannot be programmed
to any other vehicle.
WARNING!
•
Always remove the key fobs from the ve-
hicle and lock all doors when leaving the
vehicle unattended.
•
For vehicles equipped with Keyless Enter-
N-Go — Ignition, always remember to
place the ignition in the OFF mode.
Duplication of key fobs may be performed at an
authorized dealer. This procedure consists of
programming a blank key fob to the vehicle
electronics. A blank key fob is one that has
never been programmed.
NOTE:
When having the Sentry Key Immobilizer Sys-
tem serviced, bring all vehicle keys with you to
an authorized dealer.
IGNITION SWITCH
Keyless Push Button Ignition
This feature allows the driver to operate the
ignition with the push of a button as long as the
key fob is in the passenger compartment.
The Keyless Push Button Ignition has four op-
erating positions, three of which are labeled and
will illuminate when in position. The three posi-
tions are OFF, ACC, and ON/RUN. The fourth
position is START. During start, ON/RUN will
illuminate.
NOTE:
If the ignition switch does not change with the
push of a button, the key fob may have a low or
dead battery. In this situation, a back up method
can be used to operate the ignition switch. Put
the nose side (side opposite of the emergency
key) of the key fob against the ENGINE START/
STOP button and push to operate the ignition
switch.
Key Fob Battery Replacement
20
Содержание 300 SRT 2019
