Christie Solaria One, Руководство по обслуживанию

Страница: 47 / 88

Section 3: Parts and Module Replacement
Solaria One/Solaria One
+
Service Manual 3-19
020-101039-02 Rev. 1 (06-2013)
6. Disconnect the X Y Z cables from the lamp adjust assembly.
7. Disconnect the cathode lead connector from the lamp power supply.
8. Tip the lamp adjust assembly toward the front of the projector and then slide it past the reflector and out of
the lamp access door.
9. Disconnect the cathode lead connector from the lamp adjust assembly and set it aside. You will reuse the
cable when you install the new lamp adjust assembly.
3.23 Remove the Reflector Assembly
NOTICE:
Wear clean, lint-free gloves when removing the reflector assembly.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
Remove the Top Lid on page 3-4 .
4. Remove the lamp. See Remove the Existing Lamp on page 3-10 .
5. Remove the touch panel controller (TPC). See Remove the Touch Panel Controller on page 3-5 .
6. Remove the anode blower and firewall. See Remove the Anode Lamp Firewall on page 3-15.
7. Remove the 2 screws securing the lamp over temperature sensor.
8. Remove the 2 P-clips from the lamp over temperature sensor bracket and push the bracket aside.
9. Remove the 4 screws that secure the reflector module. Three of these screws are located on the bracket
outside the reflector. The fourth screw is located inside the casing below the reflector.
10. Carefully lift the reflector assembly straight up and out of the projector; do not touch the UV filter glass or
the reflector.
3.24 Replace the UV Filter
NOTICE:
Wear clean, lint-free gloves, and handle the UV filter by its edges.
The UV filter is secured to the end of the light tube. If a lamp explodes, the UV filter must be replaced.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Open the lamp access door.
4. Remove the top lid. See
Remove the Top Lid on page 3-4 .
5. Remove the lamp. See Remove the Existing Lamp on page 3-10 .
6. Remove the reflector assembly. See Remove the Reflector Assembly on page 3-19 .