Configuring Christie
NAS-S2 for GDC
SR-1000 IMB
This document describes the steps for configuring the Christie NAS-S2 as the content storage device
for the GDC SR-1000 Standalone Integrated Media Block
™
(GDC IMB).
To perform configuration changes on the GDC IMB, you must have Maintenance level permissions.
Affected products
These instructions apply to the following product.
•
Christie NAS-S2 (P/N: 108-502108-XX)
Prerequisites
The following components are required.
•
GDC SR-1000 Standalone Integrated Media Block
Overview of configuration steps
Understand the required steps for connecting the Christie NAS-S2 as a storage device for the GDC
IMB.
•
Set the Christie NAS-S2 IP address to a different subnet than the GDC IMB. For more
information, see Changing the IP address of the NAS-S2 (on page 2).
•
Delete all Christie content files from the NAS-S2. For more information, see Deleting Christie
content files (on page 3).
•
Configure the ETH1 port of the GDC IMB to an IP address compatible with the Christie NAS-S2.
For more information, see Configuring the ETH1 port on the GDC IMB (on page 4).
•
Configure the GDC IMB to use the Christie NAS-S2 as a storage device. For more information,
see Configuring storage (on page 5).
Christie NAS-S2 Configuration for GDC IMB Instruction Sheet
1
020-102909-02 Rev. 1 (01-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.
