Christie Matrix SIM, Руководство по установке

Страница: 37 / 60

Matrix StIM/SIM Setup Guide 4-1
020-100397-02 Rev. 1 (11-2012)
4 Basic Operation
4.1 Using the IR Remote
Laser radiation is emitted from the laser diode in the remote. Do not look
directly into the laser beam.
The standard IR remote can be used as a wired or wireless control. Under optimal conditions, the wireless
keypad can communicate with a projector over a 100 foot (30 m) distance. In wireless mode, the standard IR
remote communicates with the projector with a battery-powered infrared (IR) transmitter. A laser pointer is
built into the remote keypad.
When controlling a single projector, direct the standard IR remote toward the projector’s IR sensor. When
controlling multiple projectors together, direct the standard IR remote toward the screen.
Keep these guidelines in mind:
• Press keys one-at-a-time; there are no simultaneous key combinations required.
NOTE:
To use Power, Shutter, and OSD functions, press the
P
OWER
button and then press the
U
P
arrow to
switch ON or the
D
OWN
arrow to switch OFF: You can also press-and-hold the
P
OWER
button for 2 seconds,
or press it twice quickly.
• Arrow keys are held down for continuous adjustment/movement in the related key direction.
NOTE
: In serial networks, pause briefly between adjustments to make sure that more distant projectors can
“keep up” with the commands. If you press a key while the projector is still responding to the previous
action, such as during power-up, the second key press may not take effect.
4.1.1 Wired Remote
The standard IR remote can be easily converted into a wired remote using the optional cable. Connect one end
into the standard IR remote, and the other to the XLR connector labeled
Remote on the Electronics Module.
The wired remote is recommended when the lighting conditions are unsuitable for proper IR transmission.
NOTE:
Batteries are not required for the wired remote projector controls to operate; however, if the laser
pointer is required, batteries must be installed in the remote.
4.1.2 IR Remote Commands
Power ON/OFF
Press and hold
P
OWER
for 2 seconds or press twice quickly to power the projector ON or OFF. Or, press and
release
P
OWER
followed immediately by
U
P
arrow key (ON) or
D
OWN
arrow key (OFF) to guarantee the
correct action. This is useful if you are unsure of the present state of the projector.
Test
Steps forward through all internal test patterns. After stepping past the last test pattern, you will return to
current input. Press
T
EST
and then cycle by using the
L
EFT
or
R
IGHT
arrow keys, to cycle in either direction
through the test patterns. Press
E
XIT
to return to the current input.