Downloaded from Projector.com
34
Care of the cabinet
Wipe lightly with a soft, dry cloth. If the cabinet is very dirty, wipe with a cloth that has been soaked in neutral detergent diluted
with water and wrung out well. Finish with a dry cloth.
Care of the lens
Clean the lens with a commercially available blower or cleaning paper. Use of tissues, etc. may damage the lens. As the surface of
the lens is easily damaged, do not rub or hit with anything hard.
Changing the Lamp
• When the lamp reaches the end of its service life, the image becomes dark and the colors lose their vividness. When this happens,
change the lamp unit.
• When the “Approaching Recommended Lamp Life!” message appears, change the lamp unit.
• After removing the old lamp unit, handle with care to avoid breakage. Dispose of as industrial waste.
• Be sure to initialize the lamp timer after changing the lamp unit.
WARNING
• Do not remove any screws other than those specified ( mark).
The high voltage and high temperature inside the projector may lead to electric shock or burns if touched.
• When changing the lamp unit, be sure to replace with a new lamp unit. Use of a used or second-hand lamp unit may lead to
breakage or failure of the lamp.
Maintenance and Care
(continued)
1
Press the POWER button and
remove the power connector
from the power terminal.
Changing the Lamp
Allow the lamp to cool for more than 1 hour after switching off the power before changing.
2
Remove the 2 screws ( mark)
and remove the lamp cover from
the projector.
For safety reasons, the safety devices are enabled
when changing the lamp to shut off the power.
Remove power connector
