Christie FHD492-XV, Руководство пользователя

Страница: 16 / 44

Parts and functions
FHD492-XV and FHD552-XV User Manual 16
020-001139-01 Rev. 1 (08-2016)
screen. volume
Set a remote control ID when you want to pair a remote control on a specific display in an array. Before you
set a remote control ID, you must set up an ID number for each display.
1. At the top of the remote control, press and hold the ID button until the red LED blinks twice.
2. To enter ID Mode, at the bottom of the remote control, press and hold the ID SET button until the red
LED lights up.
To exit ID Mode, press and hold the ID SET button again, until the red LED turns off.
3. Enter the display number that you want to control.
You must enter digit numbers. For example, enter 01 for display number 1, and 11 for display number
11.
4. Press the Enter button to confirm your selection.
The red LED blinks twice, then turns off.
The remote control is powered by two 1.5V AAA batteries.
Caution! Failure to comply with the following could result in minor or moderate injury.
 The incorrect use of batteries can result in leaks or bursting.
 Place “AAA” batteries matching the (+) and (–) signs on each battery to the (+) and (–) signs of
the battery compartment.
 Do not mix battery types.
 Do not combine new batteries with used ones as it causes shorter life or leakage of batteries.
 Remove the dead batteries immediately to prevent them from leaking in the battery
compartment. Do not touch exposed battery acid, as it can damage your skin.
If you do not intend to use the remote control for a long period, remove the batteries.
To install or replace batteries:
1. Press and slide the cover to open it.
2. Align the batteries according to the (+) and (–) indicators inside the battery compartment.
3. Replace the cover.
When handling the remote:
 Do not subject to strong shock.