Section 4: Maintenance
Christie DS+60/DW30/Matrix 3000 User’s Manual 4-5
The optional IR remote uses two AA size, 1.5V alkaline batteries. To replace the
batteries simply turn the remote over and push out the cover using the finger groove,
as shown in (1) Figure 4.1.
Remove and properly discard the old batteries. Insert new batteries in the proper
positive/negative orientation as shown etched in the bottom of the compartment (2).
Replace the cover by inserting the tabbed end into the opening and snapping the
opposite end into place.
Figure 4.1. Replacing remote batteries
The projector uses two 300W P-VIP lamps and can be operated with both lamps ON
(Dual Lamp Operation mode) or with one lamp ON (Single Lamp Operation mode).
The projector has the ability to automatically switch modes to maintain continuous
operation.
When do I replace a lamp?
Lamps that have shown a drastic reduction in
brightness or have reached their end of life (approx 1500 hours) should be replaced
immediately. You can check the number of hours each lamp has been in use by
looking up the number of
LAMP HOURS
in individual lamp submenus or in the Status
menu. From the Lamp menu, you can also set a
LAMP LIMIT
and enable the projector
to send a warning message when it’s powered on to indicate the lamps have reached
their set limit.
At anytime during operation, you can check the status of a lamp by checking the lamp
status in individual lamp submenus – More, Lamp 1 or More, Lamp 2. You will see
one of six states: “Good”, “Cooling Fan #8 Failed”, “Cooling Fan #10 Failed,
“Interlock Tripped”, “Failed to Strike”, “Turned Off Unexpectedly”, “Color Wheel
Stopped”, “Driver Vcc too Low” or “Lamp Not Installed”. A status of “Failed to
Strike” or “Turned Off Unexpectedly” indicates a failure that requires further
investigation and may or may not be directly related to the lamp.
If you have ruled out the cause being an aged lamp or another component in the
projector, it may indicate that your lamp has prematurely burned out or failed for
some other reason (check status LEDs and/or error codes through RS-232, if
possible). Burned out lamps or lamps that have failed due to some characteristic flaw
should be replaced, as soon as possible.
In general, monitor the performance of your projector and replace lamps as needed.
4.3 Replacing
Remote
Batteries
4.4 Lamp
Replacement
Содержание DS+60
