Section 4: OPERATION
GS Series User Manual
020-000724-02 Rev. 1 (10-2015)
4-10
Menu Preferences
•
Menu Horz Offset: Change the horizontal position of the OSD.
•
Menu Vert Offset: Change the vertical position of the OSD.
•
Show Messages: Display status messages on the screen.
•
Menu Transparency: Change OSD menu background to be transparent.
NOTE:
As the value increases, more of the image behind the menu is visible.
•
Splash Screen Setup: Choose which splash screen is to be used.
•
PIN Protect: The PIN (personal identification number) feature allows you to
password protect your projector. Once you enable the PIN feature, you
must enter the PIN before you can project an image.
•
Change PIN: Allows you to change the PIN.
Power Management
•
Standby Mode: The projector is in standby mode when connected to AC
power. (<0.5W)
•
AC Power On: The projector automatically turns on when electrical power
is connected.
•
Auto Shutdown: Automatically turns the projector off after no signals are
detected for a preset number of minutes. If an active signal is received
before the projector powers down, the image will be displayed.
•
Sleep Timer: Allows the projector to automatically power off after it has
been on for a specified amount of time.
High Altitude
Set high altitude mode ON/OFF. When ON, the fan will operate at high speed
to ensure sufficient air flow for high altitudes.
Communications
•
Network: Allow you to setup network settings.
-
DHCP: Turn the DHCP ON/OFF.
-
IP Address: Assign Network IP Address.
-
Subnet Mask: Assign Network Subnet Mask.
-
Default Gateway: Assign Network Default Gateway.
-
Host Name: Display the host name.
-
MAC Address: Displays network MAC Address value.
-
Show Network Messages: Turn network messages ON/OFF.
-
Restart Network: Restart the network.
-
Network Factory Reset: Perform factory reset on the network settings.
The Projector Name, LAN IP, WLAN IP, and SNMP settings will be
reset.
•
Serial Port Baud Rate: Select the serial port and baud rate.
