Christie CP2000-XB, Руководство по установке

Страница: 29 / 66

Section 2: Installation & Setup
CP2000-XB Setup Guide 2-19
020-100250-02 Rev. 1 (06-2009)
2.5 Installing and Connecting Sources
NOTE:
To maintain radiated emissions compliance, do not connect I/0 cables to the projector without
connecting the source or receiver at the other end .
2.5.1 Cinema
Connect your server/source to either the HD-SDI A or HD-SDI B connector on the Communications and
Source Connection Panel at the rear of the projector. Connect two independent sources, or connect a single
source to both ports to create a dual-link cinema input.
2.5.2 Non-Cinema
To display alternative content from a DVI source or from Christie’s Cine-IPM 2K , remove the access panel
located on the underside of the projector near the air filter. Connect two independent sources, or connect the
Cine-IPM 2K to both ports for 10-bit processing. Add an exit hole to the panel, or leave the panel off.
Figure 2-28 Connecting Cinema and Non-Cinema
Sources