Christie CineLife+ RGB PLF CP4450-RGB, Инструкция по установке и настройке

Страница: 26 / 61

D IN-LINE B input plug
E 48V power supply B
F 48V power supply A
G IN-LINE A input plug
H UPS A plug
Before connecting the UPS device, ensure the projector is disconnected from power.
1. Remove the rear cover of the projector by unscrewing the six captive screws.
2. Disconnect the IN-LINE A input plug from the 12V power supply A (top left).
3. Remove the protective cap from the UPS A plug.
4. Connect the UPS A plug to the 12V power supply A.
5. Place the protective cap from the UPS A plug on the IN-LINE A input plug.
6. Repeat steps 2 to 5 for the UPS B and IN-LINE B plugs on the 12V power supply B (top right).
7. Reinstall the rear panel of the projector.
8. Obtain the appropriate line cord for your region and plug the cord into the UPS device, and
then into the UPS inlet on the projector.
A UPS circuit breaker
B UPS inlet (200 - 240 VAC, 10 A)
Installing the lens
The lens seals the projection head, preventing contaminants from entering the main electronics area.
Before installing the lens, ensure that you turn off the projector and the circuit breaker switches.
Installing and setting up
C RGB PLF Installation and Setup Guide–CP4450-RGB 26
020-103072-02 Rev. 1 (09-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.