Christie CC2, Инструкция по установке и эксплуатации

Страница: 17 / 40

Installation Manual 6838_05
17
Installation
|
FIG. 8
STEP 2
Remove the wing nuts and washers on the 8 mm hold down brackets. Remove the
anti-rotation brackets.
2.2 Installation
STEP 3
Insert the washer over the 8 mm bolt. Insert the bolt through the round hole in the anti-
rotation bracket and into the hole on the benchtop. Secure the 8 mm nut with two 13 mm
spanners, using one to turn the nut and the other to prevent the bolt from turning. Tighten
until the bracket cannot move. Repeat this process on the other side.
Built-in and custom cabinets:
If the 8mm bolts suit the benchtop material, fix the brackets by aligning the centre notch
on the anti-rotation bracket with the midpoint of the 495 mm cut out in the benchtop
(Centrepoint 247.5 mm). Mark this point, drill a 10 mm diameter hole on each side, and
secure as per the steps above.
Alternatively, use fixings appropriate for the benchtop material and thickness to secure the
brackets using the pre-drilled holes.