Christie 1204, Инструкция по установке и эксплуатации

Страница: 38 / 46

CC2 Gas Barbecue Cooktop
(Part numbers 1204, 1205 and 1206)
38 |
Troubleshooting
The appliance does not respond when pressing the start button.
1. Check that the button has been depressed for at least 6 seconds
2. Open the access door under the appliance and confirm that power is available. For
battery-powered units, measure the voltage with a good quality digital voltmeter. If
the voltage is below 12.4 V DC under load, the battery is flat and needs recharging or
replacement
The appliance turns on but does not ignite.
1. Contact a licensed gasfitter or suitably qualified person to check that there is gas
supply available, and it is set to the correct operating pressure
2. If this is a built-in or non-Christie cabinet, contact a licensed gasfitter or suitably
qualified person to ensure the structure has appropriate ventilation
If the fault persists, contact Christie customer support or your local technician for
assistance, providing details of the fault and the appliance serial number. The CC2
cooktop barbecue has an automatic diagnostic system indicated by green/red flashing
of the START/STOP button.
6.1 Diagnostic codes
Flashing green and red START/STOP button means an error has occurred and the appliance
has entered diagnostics mode. The flashing sequence indicates a particular Fault Code,
confirmed by a seven-second interval and audible “pip” sound. The Fault Code sequence
repeats after a 15-second interval.
A Fault Code corresponding with 1 and 2 in the Troubleshooting Chart below will remain
active until either the power supply is turned off or the fault is repaired. Fault Codes 3 and
5 will result in a 5-minute lockout, after which time the error will still display on the START/
STOP button, but you may be able to restart the appliance. A constant audible “pip” sound
with no flashing lights indicates a low voltage supply.