
Valego® RDE-58 with Flat Roof Instruction Manual
Planning the System
5
Section Dimensions and Expulsion Unit Location
Dimensions for each Section and for Expulsion Units
shown below
.
Systems 50 Sections or less
If the number of sections in the house are 50 Sections or less; only one Expulsion Unit is required and is centered
as shown in
.
Systems longer than 50 Sections
If the number of sections in the house are more than 50; two Expulsion Units are required and it is recommended
to be spaced as shown in
.
Walkover Sections
A Walkover may be desired for long Spans to allow passage back and forth. If using two Expulsion units Chore-
Time recommends centering the Walkover between Expulsion Units so there will not be any Expulsion Tubes to
walk over.
(See below)
. A half Section Walkover is also available.
See “Walk Over Section” on page 31
Planning the System
Expulsion Unit in Center of System
Each Section 94.49" [240 cm]
Center of Leg Bolts
19.69" [50 cm] Center of Leg Bolts
Center of System
Figure 1.Systems less than 50 sections long
Center of System
1/4 total length
Figure 2.Systems 50 Sections and longer
1/4 total length
1/4 total length
1/4 total length
Figure 3.Walkover Sections
1/2 Section Walkover
Centered between Expulsion Units
"x"
"x"
Full Section Walkover