Valego® RDE-58 with Flat Roof Instruction Manual
Installation
27
Expulsion Shafts
Connection at Expulsion Unit
There is a Single Sided Toothed Wheel at every Side Panel that has a Toothed Rack Plate.
Installing Expulsion Tubes until you get to a Walkover, Expulsion Unit, or in some cases the end of the System.
1.Make Sure that the Expulsion Shafts are in the forward position.
2.Set a Single Sided Toothed Wheel
(Item 1)
on every Toothed Rack Plate
(Item 2)
orienting them with the
Set Screws facing toward front and top of nest
as
shown
. Do not Tighten Set Screws at this time.
3.Slide the first Expulsion Tube
(Item 3)
through the Toothed Wheels and connect it to the expulsion Shaft
Coupling
(Item 4)
with
M8 x 40 Bolts
(Item 5)
and M8 Locking Nuts
(Item 6)
.
Panels w/Toothed Rack Plates
1
2
Item
Description
Part No.
1
Single Sided Toothed Wheel
600622
2
Toothed Rack Plate
600606
3
Expulsion Shaft
208050
4
Expulsion Shaft Coupling
603112
5
M8 X 40 DIN933 Hex Bolt
201053
6
M8 DIN985 Lock Nut
201003
Figure 31.Connection at Expulsion Unit
Panels w/out Toothed Rack Plates
5
6
3
Expulsion Shaft to Expulsion Shaft
Coupling Connection
6
4
5
Orient Wheel with one
Set Screw toward front
and one up for easier
adjustment later.