Digital Blood Pressure Monitor
Digital Blood Pressure Monitor
BP11
BP11
- 8 -
- 9 -
Unit Operation
Battery Installation
Slide battery cover off as indicated by arrow.
Install 4 new AA alkaline batteries according to polarity.
Close battery cover.
AC Adapter jack is on the right side of the monitor. Medical AC adapter(DC 6.0 V,
600mA)
can be used with the device (recommended, not provided). The adapter connect pin
should
be positive inside and negative outside with a 2.1mm coaxial joint.
Do not use any other type of AC adaptor as it may harm the unit.
System Settings
1. Select Memory Group
While in the System Setting mode, you may accumulate test results into 2
different groups. This allows multiple users to save individual test results (up to 60
memories per group.) Press “ M “ button to choose a group setting. Test results will
automatically store in each selected group.
2. Time /Date Setting
Press “SET” button again to set the Time/Date mode. Set the month first by adjusting
the “ M “ button. Press “SET “ button again to confirm current month. Continue
setting the day, hour, and minute in the same fashion. Every time the “ SET “ button
is pressed, it will lock in your selection and continue in succession (month, day, hour,
minute.)
3. Saved Settings
While in any setting mode, press “ START/STOP “ button to turn the unit off. All
information will be saved.
Note: If unit is left on and not in use for 3 minutes, it will automatically save all
information and shut off.
Applying the Arm Cuff
1. Firmly insert air plug into opening located on left side of monitor unit.