13
B: BEFORE OPERATING, CHECK OIL LEVELS AND LUBRECATION OF ALL
SLIDLING AND ROTATING PARTS. IF LUBRICATION IS NOT ENOUGH,SEE
LUBRICATION CHART AN D MAKE LUBRECATION.
C. THE LATHE HAS NO LIGHT EQUIPMENT, THE USER SHOULE PREPARE
ENOUGH FINE LIGHT EQUIPMENT AND REMOVE THE SHADOW INTERRUPTION,
AVOID LEADING DANGERS FOR THE POOR LIGHT DURING THE CUTTING
PROCESS.
D. KEEP CLAMPING THE WORKING PIECE FIRMLY PREVENT IT TO FLY OFF.
THE OUTSTANDING OF THE WORKING PIECE SHOUKD NOT BE TOO LONG IN
ORDER TO KEEP THE CUTTING PRECISION, THE RATE OF THE OUTSTANDING AND
DIAMETER SHOULD BE NOT MORE THAN 4.
E. WHEN TAKING PLACE UNEXPECTED MATTER DURING TURNING, SHOULD
PUSH THE EMERGENCY PUSH BUTTON OR TURN OFF THE POWER AT ONCE TO
STOP RUNNING.
F. WHEN NEED TO ADJUST THE LATHE OR WORKPIECE OR MACHINE TOOL,
PUSH THE PUSH BUTTON, MAKE THE MACHINE COMPLETELY STOP,THEN MAKE
THE ADJUSTMENTS.
g. CUTTING AMOUNT SELECTION: WHEN CH OOSING THE CUT AMOUNT,YOU
MUST CONSIDER THE LATHE, TOOL OR WORKPIECE RIGID, DON’T CUT
OVERLOAD, PREVENT THE DANGER FROM BREAKING. IN GENREAL, CUTTING
METAL MATERIAL AS FOLLOWING FIGURE ( SLIGHTLY ENLARGE THE CUT
AMOUNT WHEN CUTTING THE WOOD, PLASTIC, NONME TAL MATERIAL, AND SO
ON ).
WORKPIECE DIAMETER
CUT SPEED ( RPM)
CUT DEEPTH(mm)
FEED AMOUNT(mm/turn)
≥Φ150
<160
<0.5
<0.1
≥Φ100-150
<200
<0.5
<0.1
≥Φ50-100
<400
<1
<0.15
≥Φ30-50
<100
<1.5
<0.15
<Φ30
<1300
<1
<0.1
NOTE: WHEN THE RATE OF THE OUTSTANDIN G AND DIAMETER OF WORKING
PIECE IS OVER 4, THE CUT DEEPTH AND FEED AMOUNT SHOULD MAKE LESS.
H. WHEN WORKING IS OVER, TURN OFF THE POWER AND CLEAN THE LATHE.
I. WHEN DOING THE NO POWER JOB, SPECIAL AS MAINTENANCE OR REPAIR,
CUT THE MACHINE FROM THE POWER AN D KEEP SAFETY.
10.2 HEADSTOCK
Lift the cover can observe the headstock structure.
The headstock is equipped with 2 belts (1) (2), the tension of the belts has been adjusted. It
is advisable to check the tension before starting the machine. The belts shoul d depress about 1/2
inch by normal finger pressure. Too tight belts will damage the bearings, too loose belts will
lead belts to slide and speed the belt wear and tear. If necessary, adjust the tension of belts. See
the following figure, the link mechanism is provided for adjusting the tension of belts. If the belt
Содержание CZ1224
Страница 7: ...6 5 GENERAL DIMENSIONS ...
