ChiQ CPS570E, Руководство по эксплуатации

Страница: 8 / 94

EN
7
3. Level ground
Place the refrigerator on the solid and flat ground (floor) to keep it stable, or else, it will give rise to vibration and noise.
When the refrigerator is placed on such flooring materials as carpet, straw mat, polyvinyl chloride, the solid backing plates
should be applied underneath the refrigerator, so as to prevent color change due to heat dissipation.
Unobstructed ventilation shall be maintained around the appliance or in an embedded structure.
Preparations for use
1. Standing time
After the refrigerator is properly installed and well cleaned, do not switch it on immediately. Make sure to energize the
refrigerator after more than 1 hour of standing, so as to ensure its normal operation.
2.
Cleaning
Confirm the accessory parts inside the refrigerator and wipe the inside with a soft cloth.
3.
Power-on
Insert the plug into the solid socket to start the compressor. After 1 hour, open the freezer door, if the temperature inside
the freezer compartment drops obviously, it indicates the refrigeration system is working normally.
4.
Storage of food
After the refrigerator runs for a period of time, the internal temperature of the refrigerator will be automatically controlled
according to the user’s temperature setting. After the refrigerator is fully cooled, put in foods, which usually need 2~3
hours to be fully cooled. In summer, when the temperature is high, it takes more than 4 hours for the foods to be fully
cooled (Try to open the refrigerator door as less as possible before the internal temperature cools down).
If the refrigerator is installed in the moisture place, make sure to check whether the ground wire and leakage
circuit breaker are normal. If vibration noises are produced due to the refrigerator contacting the wall or if the wall
gets blackened by air convection around the compressor, move the refrigerator away from the wall. Setting up
the refrigerator may cause jamming noise or image chaos to the mobile phone, fixed-line telephone, radio
receiver, television set surrounding it, so try to keep the refrigerator as far away as possible in such case.
IV. Functions
The display panel is designed on the fridge door, illustrated as the figures below:
Function Setting
When the refrigerator system is connected to power supply for the first time, all icons on the display panel gets illuminated
for 2s, and the system runs in the Smart mode by default. When all the doors are close, the display gets extinguished
automatically if no key operation within 3 minutes. When the display is off, it will light up if any door is opened or any key is
pressed.
The following key operations are valid only when the keys are unlocked and gets illuminated on the display.