DESIGN | MANUFACTURE | SUPPORT
20
8.2
‘
Clear All RF Devices
’ Details
This is a new feature for Chiptech base units.
When
“
Yes
”
is selected and the installer moves to the next option OR exits the Installer Setup, then SEVEN will
announce
“
RF devices cleared. Enter learn mode to add devices
”. SEVEN will
clear the Device List of all the RF Devices
that have been previously learned in. No RF device will be able to activate SEVEN.
An installer can swap back and forth between
“
Yes
”
and
“
No
’
without clearing All RF Devices, only moving to the next
option or exiting will Clear All RF Devices.
9
RF Learn
Chiptech RF devices include personal help button transceivers such as Pearl pendant, Pearl watch, Pearl Advanced
with fall detection, and Chiptech GO. These should be worn at all times and can be worn in the bath or shower. Other
Chiptech transceivers include, SID fitted with third party environmental monitoring products, and fixed position help
buttons.
9.1
Learn or Replace an RF Device
•
Press the Info button
three (3) times.
•
SEVEN will beep and play the message,
“RF Learn. Please activate all your RF devices.”
•
While in the
RF Learn
mode, the Info button
will be solid red.
•
The Cancel button
light also turns on to indicate how to exit the RF Learn mode.
Alternatively, the RF Learn mode will time out after two (2) minutes*.
•
Press each of the RF devices that you want to learn in (Pearl, SID, and GO).
•
SEVEN will announce when a device has been successfully learned into the base unit, as well as its allocated zone
number
i.e. “
One RF Learned, Zone 1
.”
•
Your organisation may require you to note down and supply the zone location of each device.
•
Press the orange Cancel button
to exit. If a device has been learned,
SEVEN will play “RF Device
s Saved
.”
If
no changes have been made, SEVEN will play “RF
Devices Restored
.”
Info button light will return to green.
•
If there is no space to learn another RF device or the RF device has a low battery, then SEVEN will announce
“There is a problem learning this RF Device.”
NOTE:
There is reduced range in SEVEN when in RF Learn mode, and this reverts to maximum once back in standard
mode.
9.2
Active/Inactive RF Devices
•
When an RF device is learned into SEVEN it becomes active, which means it is continually being tracked by the
base unit. It will ‘fail to test’ if out
of range or not working.
•
If only one RF device is learned in, then it is the only active device, and any other devices previously learned into
that base unit are now INACTIVE. (Inactive devices are not checked by the SEVEN base unit).
•
When you want to learn in two or more RF devices, then they all need to be done in one learn session. All the
devices learned in during this one session will be active, all others will remain inactive.
•
There are 16 slots to learn pendants. When these are full the oldest inactive pendant is deleted, allowing more
pendants to be learned in.
•
Pressing the button on an inactive pendant at any time will make it
active
again.
