Page 9
Gas Inlet
3. Push in gas control knob slightly and turn clockwise
to “OFF”. Do not force.
4. Close control access panel.
NOTE: Knob cannot be turned from “PILOT” to “OFF”
unless knob is pushed in slightly. Do not force.
6. Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas, STOP!
Follow “B” in the safety information on this label. If you
don’t smell gas, go to next step.
7. Find pilot - follow metal tube
from gas control. The pilot
is between the two logs.
FOR UNITS EQUIPPED WITH SIT VALVES
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal injury or loss of life.
DUE TO HIGH SURFACE TEMPERATURES, KEEP CHILDREN, CLOTHING, AND
FURNITURE AWAY.
A. This appliance has a pilot which must be lighted
by hand. When lighting the pilot, follow these in-
structions exactly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
* Do not try to light any appliance.
* Do not touch any electric switch; do not use any
phone in your building.
* Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
* If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not
push in or turn by hand, don’t try to repair it. Call
a qualified service technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
E. Keep burner and control compartment clean. See
installation and operating instructions accompanying
appliance.
F. This appliance must be installed in accordance
with local codes, if any; if not follow latest
ANSI Z 223.1 for U.S. and CSA-B149 for Canada.
LIGHTING INSTRUCTIONS
(For Units Equipped With SIT Control Valve)
1. STOP! Read the safety information on this label.
2. Turn off all electric power to appliance.
3. Set the thermostat to the lowest setting or turn switch
“OFF”.
4. Open control access panel.
5. Push in gas control knob slightly and turn clockwise
to “OFF”.
TO TURN OFF GAS TO APPLIANCE
1. Turn off all electric power to appliance if service is
to be performed.
2. Open control access panel.
8. Turn knob on gas control counterclockwise
to”PILOT”
9. Push in control knob all the way and hold in. Immediately
press the red ignitor button repeatedly until pilot is lit.
Continue to hold the control knob in for about one (1)
minute after the pilot is lit. Release knob and it will pop
back up. Pilot should remain lit. If it goes out, repeat steps
4 through 9.
*If knob does not pop up when released, stop and
immediately call your service technician or gas supplier.
*If the pilot will not stay lit after several tries, turn the gas
control knob to “OFF” and call your service technician or
gas supplier.
10. Turn gas control knob counterclockwise to “ON”.
11. Close control access panel.
12. Set the thermostat to the desired setting or turn burner
switch “ON”.
13. Turn electrical power “ON”.
Gas Control Knob
Shown in OFF
Position
PILOT
BURNER
THERMO-
PILE
Содержание BWI-30A
Страница 16: ...Page 16 NOTES ...
