Chinook Fireplaces BWI-30A, Руководство для владельца и по установке

Страница: 6 / 16

Page 6
TOP BRASS EDGE TRIM
REAR VIEW
OF ASSEMBLY
TOP SUB-FRAME
ATTACH W
/
BRASS SCREWS
RIGHT
SIDE BRASS
EDGE TRIM
ATTACH W
/
BRASS SCREWS
SIDE
SUB-FRAME
SIDE
SUB-FRAME
LEFT
SIDE BRASS
EDGE TRIM
(
HAS SWITCH
KNOCK
-
OUT
)
BURNNER
ON
/
OFF SWITCH
1. Align mounting holes in face assembly with mounting holes in outer flanges of insert and secure with sheet
metal screws provided.
2. Install top grill with 6 louvers using two sheet metal screws provided.
3. Install bottom grill with 5 louvers by securing hinges to tabs in base of unitwith screws provided (2 per side).
TRIM KIT INSTALLATION
NOTE: The installation and testing of the fireplace insert should be complete before
installing trim kit.
SUB-FRAME ASSEMBLY
1. Unpackage all parts. Remove plastic protective covering from any brass parts.
2. Lay parts to be assembled face down on a carpeted or blanketed floor. Take care not
to scratch parts.
NOTE: Side parts are interchangeable from left to right.
3. Install nuts and bolts as shown in figure below.
Note: If you have purchased the optional brass face kit, refer to instructions in that kit
before installing side brass trim.
4. Install side brass trims over the outer edges of face as shown. Attach with brass
screws provided. Make sure trim with switch knock-out is located on left side.
5. Install the top brass trim over the top edge of face as shown. Attach with brass screws provided.
6. Install burner on/off switch into rectangular knock-out in left side brass trim (see illustration).