22 / 39
FISIOLASER IRD/IRD 2
11)
For to stop definitively the emission of the treatment , press the STOP
button
Emission in “Continuous” modality
For to emit the treatment in continuous modality , please follow these instructions :
1)
Press the function taste relative to the SETTINGS button ( see fig. 4 )
2)
Rotate the encoder knob until to position the cursor on the “probe” menu
3)
Press the encoder knob in correspondence of the PROBE menu ( see fig. 9 )
4)
Press the encoder knob on the first menu
5)
Rotate the encoder knob until to select the “Continuous emission” option (
see fig. 16 ) :
Fig. 16
6)
Press the encoder knob for to confirm the choice
7)
For to abort the operation , press the function taste relative to the CANCEL
button , otherwise press the function taste relative to the SAVE button ( see
fig. 16 ) : you return to the screen of fig. 9
8)
Press the function taste relative to the EXIT button ( see fig. 9 ) : you
return to the screen to fig. 4
9)
Press the function taste relative to the FREE PROCEDURE button ( see fig.
4 ) ; it appears the screen of fig. 13
10)
Press the START button for to run the default treatment in the selected
modality
11)
The probe emits now in continuous modality , not depending by the contact
with the patient ; for to suspend the treatment press the STOP button ; this
operation will enter the device in “paused” state
12)
For to restart the treatment by the interruption point , press again the
START button ; otherwise , for to stop definitively the emission of the
treatment , press again the STOP button
Pushing the function taste relative to the channel , is possible to alternate the screens
relative to the programs loaded on both the channels ( see fig. 17 ) :
Fig. 17
IMPORTANT: The amount of power which appears in the display refers to the
transmission power of a single god. For handpieces with more diodes each diode
emit the indicated power.
Otherwise , pushing the function taste relative to the EXIT button , you return to the
screen of fig. 4 .
NOTE
Any time a different hand-piece is used,
it must be set within this section.
N.B.
Output channel 1 is the only one available in the FISIOLASER IRD .
NOTE
You must also enter the area of the part to be treated.
The surface area to be treated must be entered in the probe entry (“Area 1”, “Area
2”) ( see fig. 11 ) .
The power emitted will be adjusted in inverse proportion to the area .
! WARNING !
As the laser radiation that escapes
Save
Cancel
* * CHANNEL <1> * *
CHANNEL 1
MLA 1/25 Personalized
15:00
CHANNEL 2
15:00
Channel 2
Exit
