Installation of Mixing Valve
When installing the 3 way valve please use Teflon tape on the
fitting ports to prevent any water leakage. The 3 way valve must be
installed with the white actuator on top as shown below. Secure the
valve to a mounting board if it is directly connected to PEX tubing on
all ends. The orientation of the position of the valve (0 to 1) at time of
install does not matter, it will be addressed later in the manual.
IMPORTANT NOTE
The mixing valve, cross connect piping, and PT100, MUST all be on
the manifold supply line and MUST be “upstream” of the pump(s)
as shown in the various diagrams of this manual.
Above, valve supported by copper pipe on 2 sides
8
