CXRC1 Controller Operation
The controller has firmware to read the sensors and control the valve
position, the end user will need to set a temperature dew point offset.
This temperature may the set by the user to automatically track the dew
point, or may be set to operate at some delta above or below the dew
point.
Note: In many cases the water temperature can be safely set below the
dew point. See the section on temperature selection.
Ex: If you set the controller at “+2F” the controller will operate with a
target temperature to the supply manifold as “dew point plus 2 degrees
Fahrenheit”.
The controller will cycle between two different menus as shown below.
13
