Installation Instructions
YSM2
7
1.
Using a stud finder, locate and mark the two studs to which
the YSM-2 will be installed.
2.
Using a nail through the center hole of the wall bracket (A),
temporarily hang the wall bracket on the wall at the install
location. (See Figure 1)
3.
Align mounting holes in wall bracket (A) with studs.
4.
Mark location of four mounting holes on wall. (See Figure 1)
5.
Drill four pilot holes. (See Figure 1)
Figure 4
6.
Hold metal channel on anchor (L) flat along side plastic
strips and slide channel through hole. (See Figure 4)
7.
Holding plastic straps on anchor (L), pull anchor away from
wall until channel rests flush behind wall making sure
anchor channel is positioned vertically on stud as shown
following figures. (See Figure 5)
Figure 5
8.
Slide plastic cap on anchor (L) towards wall until cap flange
is flush with wall. (See Figure 5)
9.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 6)
Figure 6
10. Repeat Steps 6 through 9 for each mounting hole.
11. Place wall bracket (A) over anchors and align mounting
holes in wall bracket with holes in anchors. (See Figure 7)
12. Place four flat washers (K) onto four 1/4-20 x 1-3/4" Phillips
pan head screws (J).
13. Insert Phillips pan head screws (J) with flat washer (K)
through mounting holes in wall bracket and into anchor (L)
and tighten until flush against wall bracket. DO NOT
overtighten!
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAMGE TO EQUIPMENT! Overtightening
mounting hardware can damage the steel studs. DO NOT
Drywall
Plastic Straps
(L) x 4
Anchor
Metal Channel
Steel Stud
Drywall
Plastic Cap
Anchor Metal Channel
SIDE VIEW
(L) x 4
Steel Stud
Drywall
Plastic Cap
Plastic Straps
Anchor Metal Channel
SIDE VIEW
