CHIEF Thinstall TS110SU, Руководство по установке

Страница: 7 / 12

Installation Instructions TS110SU/TS118SU
7
Install Main Assembly to Wall
-
Hollow
Concrete Block, Poured Concrete or Clay
Brick
WARNING:
Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component. Do NOT install to a concrete wall of any kind that
has a drywall covering!
WARNING:
INSTALLING THE TS110SU/TS118SU INTO
UNDERRATED OR DAMAGED CONCRETE CAN LEAD TO
SERIOUS INJURY OR DAMAGE TO PRODUCT! Never
install the TS110SU/TS118SU into cracked, chipped or
flaking concrete.
1. Determine mounting location.
2. Measure 2 5/8" above desired center line if mounting
TS110SU or 1" below desired center line if mounting
TS118SU and mark a hole at desired mounting location.
(See Figure 4)
IMPORTANT ! : Use a level to make sure main assembly
(H) is level when mounted to the wall!
IMPORTANT ! :
The TS110SU/TS118SU mounts are
designed to be mounted to an 8" concrete, 8"x8"x16" concrete
block or clay brick wall.
3. Drill one 8mm hole at location marked in Step 2. (See Figure
4)
Figure 4
4. Install one concrete anchor (F) into drilled hole. (See Figure
5)
5. Install one 1/4 x 2 1/2" lag bolt (E) into concrete anchor (F),
leaving bolt hanging out 1/2" from the wall. (See Figure 5)
6. Hang main assembly (H) onto lag bolt (E) by latching key-
shaped hole over top of bolt. (See Figure 5)
Figure 5
7. Mark hole at lower mounting hole location. (See Figure 6)
8. Remove main assembly (H) from wall.
9. Drill 8mm hole at marked location. (See Figure 6)
10. Install remaining concrete anchor (F) into drilled hole. (See
Figure 6)
11. Hang main assembly (H) back onto wall.
12. Install remaining 1/4 x 2 1/2" lag bolt (E) into concrete
anchor (F) to secure mount to wall. (See Figure 6)
13. Tighten both lag bolts (E) to fully secure mount to wall.
Figure 6
2 3 8mm
screen
center
2 5/8"
TS118SU
TS110SU
screen
center
1"
(E)
6
1/2"
5
4
(F)
(E)
(F)
(TS110SU shown)
(E) 12
7
9
10
(F)
(TS110SU shown)