CHIEF Thinstall TS110SU, Руководство по установке

Страница: 9 / 12

Installation Instructions TS110SU/TS118SU
9
Wall Cover Installation
CAUTION:
Wall covers are fragile and may be damaged or
broken if installed with excessive force! Use caution when
installing and removing wall covers.
1. Pull apart top or bottom section of wall cover (J) so that it fits
over the main assembly arm. For the TS110SU pull apart
the top and for the TS118SU pull apart the bottom. (See
Figure 9) or (See Figure 10)
2. Install wall cover (J) onto main assembly making sure holes
on cover latch over tabs on main assembly. (See Figure 9)
or (See Figure 10)
Figure 9
Figure 10
Cable Management
1. Make all cable connections to display.
2. Open cable management covers on upper and lower swing
arms by unhinging center tabs and lifting covers to the open
position. (See Figure 11)
Figure 11
3. Route cables on top of upper arm. (See Figure 12)
NOTE:
Cable ties (not included) may be used to secure cables
to back of faceplate using cable tie holes on either side
of faceplate.
4. (Optional) Use cable ties (not included) to secure cables to
upper arms by threading ties around cable and through
cable tie holes inside the covers. (See Figure 12)
5. Close upper cable management cover. (See Figure 12)
6. (TS118SU only) Route cables under lower portion of swing
arm. (See Figure 12)
7. (Optional for TS118SU only) Use cable ties (not included) to
secure cables to lower arms by threading ties around cable
and through cable tie holes inside the covers. (See Figure
12)
8. (TS118SU only) Close lower cable management cover.
(See Figure 12)
Figure 12
1
2
1
(H)
(J)
TS110SU
1
2
1
TS118SU
(J)
(H)
2
center tabs
2
3
4
cable ties
(not included)
6
cable (typical)
(TS118SU shown)