Installation Instructions
QMP1MM2
5
Recessed Display Installation
1.
Uninstall end lock from dual array assembly (A) using the
5/32" hex key (J). (See Figure 4)
Figure 4
2.
Remove Centris head from array rail. (See Figure 5)
Figure 5
3.
Carefully place display face down on a clean and dry
surface.
4.
Determine depth of recessed mounting holes relative to
back surface of display.
5.
Select proper length spacer and screw from table below:
IMPORTANT ! :
All spacers used should be the same
length. If the recess depths result in multiple spacer
lengths, then select the longer spacer.
6.
Place the four spacers (F or G) over each mounting hole on
the back of display. (See Figure 6)
7.
Orient mount so that mounting holes in the Centris cup are
aligned with the holes in the spacers (F or G); rotate the
Centris cup as required (See Figure 6).
CAUTION:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display! Proper screws will
easily and completely thread into display mounting holes.
8.
Install four M4 x 20mm (D) or four M4 x 30mm (C) Phillips
head cap screws through the mounting holes in Centris cup,
through the spacers (F or G), and into display (See Figure 6).
9.
Tighten all four screws. Do not overtighten!
Figure 6
10. Slide display with Centris bracket onto array rail. (See
Figure 7)
NOTE:
Repeat previous steps for the additional display.
Figure 7
IF recess DEPTH is: THEN use spacer:
AND screw:
3/8" or less
F (3/8" long)
D (M4 x 20mm)
More than 3/8" up to
and including 3/4"
G (3/4" long)
C (M4 x 30mm)
Square nut
End lock
Centris head
1
x 1
(A)
Centris head
2
(A)
TOP
(C or D) x 4
(F or G) x 4
6
7
Centris
cup
Display with
(Display not shown)
(A)
Centris bracket
Содержание QMP1MM2
Страница 7: ...Installation Instructions QMP1MM2 7 ...
