CHIEF QMP1MM2, Руководство по установке

Страница: 4 / 8

QMP1MM2 Installation Instructions
4
ASSEMBLY
The QMP1MM2 is designed to be attached to the inner column
of Chief carts and stands.
1. Attach column to cart/stand base (not included) following
instructions included with cart/stand (not included).
2. Fasten array clamp (B) around the cart/stand inner column
and to the dual array assembly (A) using two 1/4-20 x 3/4"
button head screws (H). (See Figure 1)
NOTE:
The QMP1MM2 attaches only to the INNER column of
the Chief cart or stand.
Figure 1
DISPLAY INSTALLATION
The mounting holes on the back of the displays will be flush
with the back surface, or recessed into the back. Refer to the
applicable installation procedure below.
Flush Display Installation
CAUTION:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display! Proper screws will
easily and completely thread into display mounting holes.
CAUTION:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Inadequate thread
engagement in display may cause display to fall! Back out
screws ONLY as necessary to allow installation of Centris
cup!
1. Ensure Centris cup is able to swivel and tilt easily, yet still
be tight enough to hold display in desired position. Adjust
as required before proceeding. See
Adjustment section
for details.
2. Carefully install two M4 x 12mm Phillips head cap screws
(E) into the
upper mounting holes on the display. Thread
screws completely into display, then back out 3 complete
turns.
3. Align two screws (E) with the two top teardrop mounting
holes on the Centris cup and lower Centris cup onto
installed screws. (See Figure 2)
CAUTION:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Smaller area of
teardrop mounting holes must be facing downward for proper
installation. Reposition Centris cup if required.
Figure 2
4. Install two M4 x 12mm Phillips head cap screws (E) through
the
lower mounting holes in Centris cup into the display.
(See Figure 3)
5. Tighten all screws. Do not over tighten!
NOTE:
Repeat previous steps for the additional display.
Figure 3
6. Proceed to Cable Management section.
2
(H) x 2
Cart/stand
(A)
(B)
column
inner (E) x 2
3
2
(A)
(E) x 2
Centris Cup
4
(A)