universal mobile rotating panel stand
model no:
mK73
thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. saFetY
i
9
only use on firm, level, unobstructed surfaces which are capable of supporting the stand.
8
do not
overload.
9
Always load the stand carefully to ensure maximum balance and stability.
8
do not
stand/ride on the stand, or allow others to do so.
9
Replace or repair damaged parts. Use only recommended parts. Unauthorised parts may be dangerous and will invalidate the warranty.
Warning!
Failure to comply with these instructions may result in loss of load, damage to the stand or other property and/or personal
injury.
Warning!
The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions
and situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator.
2. introduction
Ideal for doors, bonnets, bumpers, wings and spoilers.
Adjustable and rotating bars make this stand suitable for
almost all panel types. Portable for easy manoeuvring
of application from preparation to spray booth.
Includes: S Hooks (x2), Spray Gun Holder, Vertical
Supports with Fixed Hooks (x4), Supports with Holes (x2).
3. speciFication
model no.: ....................................................................mK73
max. capacity ................................................................. 60kg
overall length ........................................................... 1240mm
Short adjustable bar length ........................................ 400mm
long adjustable bar length ......................................... 700mm
Height without bars .................................................... 950mm
4. assemblY
refer to attached parts diagram
o
note:
It is advisible to seek assistance of another person whilst assembling.
4.1.
Assemble frame first then attach extension frame for holding panels.
4.2.
Assemble bottom frame (5) rear brace (4) front upright bar (11) and foot frame (28).
4.3.
Assemble stand frame only parts (1 and 2) at this point.
4.4.
Insert stand frame parts to parts (4 and 11) by attaching handle (10).
4.5.
Attach wheels and other ancilliary parts shown on Parts diagram.
4.6.
Check all fixings for tightness.
5. operation
5.1.
Before placing panels on the stand the pin needs to be inserted through the vertical locking bar and
secured with its R pin. Check that the vertical bar has engaged with the cog.
5.2.
Take the weight of the panel/s by holding the handle before attempting to remove the locking pin.
5.3.
Rotate the panel stand by placing a foot on the pedal (with the pin removed.)
5.4.
ensure that the pin is reinserted before moving the panel stand.
5.5.
move by lifting the two handles.
mK73 Issue 1 25/11/19
Original Language Version
© Jack Sealey limited
Refer to
instruction
manual
Wear
protective
gloves
Wear
protective
clothing
Wear
protective
footwear
